i'd say your best bet would be to get a cheap set of used a-arms on ebay. I lucked out and got a set of both upper and lower a-arms for $40. they was a little dirty and greasy but all the ball joints were tight. I just cleaned em up and put a coat of black paint on em and they turned out great. heres a pic
__________________
86' honda 250R woods bike
fresh motor as of sept. 9th 08'
esr trx 5 pipe and silencer
38mm air stryker carb
stock cyl. with 68mm wiseco piston (86')
cr thin head gasket
180psi compression (stock head)
88' hot rods stock crank with spacer plate
vforce 3 reed valve
01 cr250 ignition system
+4 axle
13/38 gearing
durablue lowering strut
maier front and rear fenders
|