[RIPRuck]

Hey guys, I'm new here from the HQ and happy to find this site.. I'm having some jetting issues with my 2 into 1 carb and would like to hear from others. I'm getting a bog at around half throttle when I nail it. Top and bottem end are completely fresh along with the 2 into 1, exhaust and port job. Here are my motor mods!

Trinity CV 2 into 1 intake
38mm PWK airstriker
Herr jugs aggressive trail port
DMC 916 exhaust
Timing @ +4
Vforce 3 reeds
185 main
50 pilot
DDJ, EEK needles 3rd clip
Sea level 35 degrees

Carb came with a 195 main and 52 pilot with the DDJ needle. With that configuration I would get a hesitation off idle into the rpm's. When I switched the needle to the EEK the off idle hesitation went away but now have a half throttle bog. Tried it with a 210 main which made it worse and then tried a 185 which got a little better but not sure if I should go any lower. Anyone else have this similar setup that can shed some light? It idles great.. Thanks!!