[bfulton620]

hey fela's.... long time no post.... I recently purchased a tors removal kit... i followed the instructions and installed it.... i think i might have ran into a bit of a problem with the protruding angled shaft, in witch you tap the slid screw hole.... how much were you supposeed to sand off of this? my instructions said flat, but my carbs barely open 1/16" of an inch on either side...

1) how far should the slides screw be able to adjust the slide?

2) do i just kick it over. see if she starts, then move the screws in a little, and try againg? is it that easy?

Thanks for the help in advance.... and special thanks to climbany, for finding me a "pretty blue anodized tors removal kit with stainles lines".... it looks beautifull!