| | |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
09-11-2007
| ||||
| ||||
 Thats not good dealing. I hope we can help get to the bottom of this transaction.
__________________  First level of mining... See the big diesel engines and the little tiny people? -Greg     |
| Sponsored Links |
|
09-11-2007
| ||||
| ||||
| Those motors are different...period. Did the seller tell you about the siliconed holes and cracks? if not...get your money and motor back. The hole in the case is no big deal. MY 85 did the same thing from a chain break. I literally drained the cases, cleaned up the area with brake clean, folder over a thin piece of copper till it was 1/16 of an inch thick or so...then JBWelded it. Held for years, and still holding when I sold it... Could probably do the same for the side cover... The question here isn't if it's fixable, it's if it's the same motor...it's not....and that's BS...look at how much more oil is on the motor near the hole...
__________________ I run on alky, and so does my bike...  |
|
09-11-2007
| ||||
| ||||
| I stand corrected upon further inspection. At any rate I feel your pain. Silicon???? I would also be curious about the sellers intent sometimes mistakes can be made. Hopefully it was inadvertent.
__________________ "Paul, Thanks for sending the pictures - looks like a lot of fun! You did a great job." Regards, Hannah  |
|
09-11-2007
| ||||
| ||||
| i uderstand your restraint on calling the person out who wronged you ,if you feel we can help or vindicate this in some way your more than welcome to private message me and i will not openly disclose the parties name and the mods will see what can be done to help i n some way get this all fixed for you
__________________ CLICK BELOW FOR MY NEW SITE http://flotekperformance.com/home http://www.rjatv.com/ cheapest ^^performance parts online |
|
09-11-2007
| ||||
| ||||
| is this going to be like that offraod trucks thread? the dude that cashed the check on the gears
__________________ Danny   |
|
09-11-2007
| ||||
| ||||
| Quote:
__________________ "Paul, Thanks for sending the pictures - looks like a lot of fun! You did a great job." Regards, Hannah |
|
09-11-2007
| ||||
| ||||
| Post his name so that we can put a bounty on his ass!
__________________ E2S MODERATOR  "E2S BOUNCER" 2003 Banshee Lonestar +2+1 Polished A-Arms Gforce +2/+4 Polished Axle 370banshee Monster Port Procom High Rev CDI Toomey T6 Exhaust V-force 2 Reeds Special thanks to RJATV! Visit rjatv.com for all of your atv parts! SI MAFIA LEADER www.showtimeindustries.com  |
|
09-11-2007
| ||||
| ||||
| yes they are not the same motor the clutch cover looks like it's from the motor with the "weld" and if you look close the stator wire has the 2 factory looms the motor sent does not along with the other stuff mentioned above being different and why the switched clutch cover ? I'd check the water pump and the clutch cover over good I'll bet they switched something there for a reason clearly a bait and switch deal !!!! good luck |
|
09-11-2007
| ||||
| ||||
| They do look different, but even in the first pic you can see the same hole, though it looks like it has a welded patch in that one.
__________________ Josh __________________________________________________ ___________________________ "Who could have possibly envisioned an erection - an election - in Iraq at this point in history?" President George W. Bush __________________________________________________ ___________________________ '86 TRX 500R Hand built frame '86 CR 500 motor FMF pipe Power Pros silencer Durablue rear axle 38mm PWK A/S K&N filter Bald ass rear tires from doing donuts in the street |
|
09-11-2007
| ||||
| ||||
| theres a bolt missing on the top of the cover of one of them, id say they are not the same or parts have been changed
__________________ ANDY  my 2000 blaster foam filter from toomey 4 degree key from dustin420 toomey b1 oil block off kit Boysen power reeds worn out stock front tires 20x11x8 razr bored .020 over 3mm stroker have flotek port and polish to match stroke this winter when i get the money, if i can work more then 3 days in a row |
|
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
All times are GMT -4. The time now is 04:04 PM.
Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Car Insurance | Remortgage | Car Insurance | Credit Cards | eHarmony
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
Copyright 2005 everything2stroke.com
