| | |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
07-22-2008
| ||||||||||||
| ||||||||||||
 there is a guy on blaster forum that has a 280cc blaster! says it was manufactured by trinity.
__________________ LIFES FAST SOOOOOOO HAUL ASSSSSSSS s.i.mafia      |
| Sponsored Links |
| |
|
07-22-2008
| ||||||||||||
| ||||||||||||
| trinity does in fact make a big sleeve and if your ran enough stroke im sure it could get there but it would probably be a terd compared ot a 240 thats setup right
__________________ CLICK BELOW FOR MY NEW SITE http://flotekperformance.com/home http://www.rjatv.com/ cheapest ^^performance parts online |
|
07-22-2008
| ||||||||||||
| ||||||||||||
| well flo while u are handing out advice.... let me ask ya this. y when raising the compression would u mill the head and not the cylinder? dont u want 75% of the combustion tacking place in the head vs the cylinder?
__________________ LIFES FAST SOOOOOOO HAUL ASSSSSSSS s.i.mafia |
|
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
All times are GMT -4. The time now is 12:56 AM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Beijing Olympic | Debt Consolidation | Credit Counseling | Credit Reports | Loans
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com
