Stock Blaster Tors Cap Switch

[BlasterMod6]

To make the motor run does the switch on the tors cap need to be closed or open? Im bypassing it and need to know. Thnx

[holtzer1]

you need to compress the switch...close it. the last one i did..i just used electrical tape tightly wound around it, just in case they wanted to put the tors back on.

[BlasterMod6]

so to make the engine run the wires have to be conencted? I ripped my switch off.

[ajh97blaster]

when i switched to twist throttle, i had an problem with the bike idling,...basically thats all it did the TORS was doin its job, so after a few calls around i found out about the tors and i cut the wires and wire-nutted and taped them up and its worked fine for me since...i guess its bypassed!?

[holtzer1]

yup...lol...tie em together, best way is to solder em.