pics of nelsons yamazuki

[NELSON]

access is always easy..... after a case!

[jsmstorm]

Bike is looking good man!!!! Get some videos up when you get her going!!!

[lt250racer]

Nelson, Looking good.
How are you going to get that swinger bolt thru the engine? In the pictures it looks like it wont line up.
Could be the angle though.
I would imagine it would be lighter than 300 pounds.
Good luck & keep us posted on the progress!!!

[rm250dude]

Originally Posted by NELSON

access is always easy..... after a case!

hahahahahahahahahahahahahahahahahahahahaahahahhaha hahahaah lmao

[NELSON]

the bolts fit. i took a pic with them in but my wifes computer took a shit last night.... again. when making the mounts i put the swinber bolt through first and made a washer for each side to get the chain to line up straight, once this was done i sat a thin board under the frame to lift the motor up a bit and then made the bottom lower mount.i then installed that bolt. with those 2 installed and tightened i made the front. so they are all there!

[xxxbansheexxx]

Nelson, Looking good.
i seee lots of laeger
parts
just wondering is that the same 250r that was a craigslist
like 1-3 months ago cause it looks real similar
if not it is one swweet bike
gotta love the hybrids

[NELSON]

no i have had it a bit. i popped the engine and it was too much to repair. hence the birth of the hybrid! blaster parts are every where, and can make good power, equivilant to a lt. i decided when my wifes blaster was runnin side by side with my piped 250.

[xxxbansheexxx]

oh sounds good
it looks really really nice it is going a sweet hybrid

[sugarcoated]

pics of nelsons engine... ALMOST REDY new seals new bearings and some bling bitch!

[sugarcoated]

nelson's engine pics new seals new bearings and some bling bitch!