| ||||||||
![]() |
| | LinkBack | Thread Tools | Display Modes |
| Sponsored Links |
| |
| ||||||||||||
| I had to cut the middle bar and weld in a pipe diagonally. I also had to make some mounts. In the back, the engine is more narrow than the swingarm bolt, so you will need to but some washers in as spacers. Make sure you line up the sprockets with the washer spacers. Hopefully the pictures will help with the middle pipe.
__________________ 88 250r Motor - 4mm stroker mx ported, Sparks pipe, 38mm AS, v force reeds, Hinson basket w/ Barnett plates Chassis - PRD narrow frame, Janssen +3 arms, Ohlins LT big bodies, cr500 link Walsh swing arm, Ohlins rear shock, LSR axle, Denton stabilizer, AC propegs |
| |||||||||||
| what KX engine is that?
__________________ Place use to be my escape from daily hardship...thanks for ruining it. |
| ||||||||||||
| 2000 kx250
__________________ 88 250r Motor - 4mm stroker mx ported, Sparks pipe, 38mm AS, v force reeds, Hinson basket w/ Barnett plates Chassis - PRD narrow frame, Janssen +3 arms, Ohlins LT big bodies, cr500 link Walsh swing arm, Ohlins rear shock, LSR axle, Denton stabilizer, AC propegs |
![]() |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
| |
All times are GMT -4. The time now is 04:36 AM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Online Loans | Guitar Lessons | Loans | Online Loans | Loans
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com





































Linear Mode
