| | |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
11-24-2007
| |||||||||||
| |||||||||||
 Where to buy exhaust parts Hi all, new to the site. I am building an H2R replica out of my 74 Kawasaki H2. I need to fabricate new expansion chambers. Does anyone know where I can buy the cones, pipes, etc. to fab my own? I have been looking with little luck. I heard Jemco will sell parts buy I can't get through to them and have left messages. Any help would be greatly appreciated.      |
| Sponsored Links |
| |
|
12-08-2007
| |||||||||||
| |||||||||||
| Anybody? What I really need are the cones. What have you guys done to fabricate exhaust? Did you just chop up old sets of pipes? There must be a place to buy parts. |
|
01-09-2008
| |||||||||||
| |||||||||||
| Did I just see a tumbleweed roll by? |
|
01-09-2008
| ||||||||||||
| ||||||||||||
| you can try www.bikebandit.com they have all sorts of oem parts, but they tend to discontinue some of the rare parts
__________________ 86' honda 250R woods bike fresh motor as of sept. 9th 08' esr trx 5 pipe and silencer 38mm air stryker carb stock cyl. with 68mm wiseco piston (86') cr thin head gasket 180psi compression (stock head) 88' hot rods stock crank with spacer plate vforce 3 reed valve 01 cr250 ignition system +4 axle 13/38 gearing durablue lowering strut maier front and rear fenders |
|
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
All times are GMT -4. The time now is 09:15 PM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Mortgage | Problem Mortgage | Loans | Loans | Debt Consolidation
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com
