blaster idle screw

[BlasterGuy]

Sorry if this is the wrong place.First i wanna say hey im new here and what a nice site. My problem is i just got a 1993 blaster it runs fine just wont idle and was wondering where the idle screw is. Thanks jay

[erik6767]

should be a little brass colored screw on the side of your carb

[BlasterGuy]

Hey thanks i think i got it. But i think the problem is the gasket is leakin at the reeds. So i ckeck it tom. but thanks Jay

[chase.mosher]

With mine it's under the seat under a black plastic mud guard. It's a big silver screw.

[BlasterGuy]

I see the thing your talkin about. That looks more like it but gotta fix the gasket at the reeds to see. But thanks for the info. Thanks jay

[yam2stroke]

If you still have the TORS on your bike, the big piece of junk box on your carb, then there will be a big silver screw under seat right on top of the tors box. Also you can get it to idle a little better by adjusting the throttle cable where it goes into the thumb throttle assembly. Also some advice: get rid of the tors, it will only cause problems down the road.

[BlasterGuy]

How you do that im really new to this blaster and never really worked on a four wheeler before. Is there a kit or a special cable you need. thanks jay

[yam2stroke]

They sell tors eliminator kits, you can pick them up at rocky mountain or dennis kirk.

[99honda99]

what does tors do?

[imgladihaveabanshee]

TORS is your throttle override system. It is in case your throttle sticks it won't let your engine rev up. They seem to get faulty over time like the ones on my banshee did. The kits to eliminate this are about $50, and I got mine at motionpro.com. I don't know about the blaster but with the banshee you have to buy an additional idle screw kit that has to be drilled and tapped into your carb. Thats like another $50. But you have to get it.
Mike