| | |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
05-03-2008
| |||||||||||
| |||||||||||
 Where to start with jetting? Need some advice on a good jetting starting point, here are the mods. Bored 1.5mm over Some kind of aftermarket pipe, I think it is DG Shaved head Ported cylinder Just got the machine running today and it seems like if I go full throttle, or over half actually it bogs. Not sure if I am too big or small on the jet so hopefully someone can give me a starting point.
__________________ ---------------------------------- 86 250r Project 1.5mm Overbore Stage III port job by Brown Performance (Anyone Heard of them??) Titanium Rod from a CR250 ESR TRX 5 Pipe Twin Air Filter Shave Head, doing absolutly nothing as the piston seems very low in the jug. Current State: Trying to figure out the damn jetting. Soon to be added mods (when cash flow permits): Air Stryker carb cr250 V-Force 2's (if the guy I found still has them in stock when I get the cash)      |
| Sponsored Links |
|
05-04-2008
| ||||||||||||
| ||||||||||||
| first thing do have a stock size carb? |
|
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
All times are GMT -4. The time now is 07:35 PM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 eBay | Mobile Phones | Pio baroja | Loans | Web Advertising
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com
