| | |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
11-26-2007
| |||||||||||
| |||||||||||
 cr125 does any one know can you port a cr125 JUG and where is a good place to get rebuild kits i think it is a 85 but not sure i have the numbers off the engine je01e 600528 thanks Last edited by kvpracing; 11-26-2007 at 04:30 PM.      |
| Sponsored Links |
| |
|
11-26-2007
| ||||||||||||
| ||||||||||||
| I dont believe you can port the head, but you can mill it down to gain compression. but you can port the cylinder for more usable power. and you could try this place for engine rebuild parts http://www.psep.biz/index.htm
__________________ 86' honda 250R woods bike fresh motor as of sept. 9th 08' esr trx 5 pipe and silencer 38mm air stryker carb stock cyl. with 68mm wiseco piston (86') cr thin head gasket 180psi compression (stock head) 88' hot rods stock crank with spacer plate vforce 3 reed valve 01 cr250 ignition system +4 axle 13/38 gearing durablue lowering strut maier front and rear fenders |
|
11-26-2007
| |||||||||||
| |||||||||||
| does anyone kno how to find out the year??? |
|
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
All times are GMT -4. The time now is 09:59 PM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Personal Loan | WoW Gold | Mortgage Calculator | Pio baroja | Gas Suppliers
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com
