intake spacer for a 90

		E2S > Performance > Intake Mods
intake spacer for a 90

LinkBack

Thread Tools

Display Modes

#1 (permalink)

09-26-2007

kildea250r Offline

Bent Wrench Racing

Join Date: Sep 2005

Location: Missouri

E2S Coin: 200

View Albums

Classified Rating: 0% (0)

kildea250r is an unknown quantity at this point

intake spacer for a 90

I have an artic cat 90 and replaced the stock carb (16mm) with a 20mm. The float bowl now hits on the cyl shroud used for cooling. I was curious if I machined a spacer for the intake would it go between the reeds and cyl or between the reeds and intake boot?

I thought on my 250r that the spacer goes between the reed cage and the cyl. Is this correct? Also what would the maximum thickness I should go? I read some other posts sayin 3/4 inch was way to much.

Please help so I can get my daughter back on the trails.
Thanks

__________________
'86 TRX 250R
-fmf pipe/silencer
-uni filter
-mx ported cyl.
-maier front plastic
-barnett clutch
'01 BLASTER
-bored .040
-shaved head
-lrd full exhaust
-injection block off
-k&n filter
'86 LT50
-restricter washers removed
-pimpin rear tires
-ebay plastic
-found in the trash
-biggest smile from my boy (PRICELESS)
'02 Artic Cat 90
-restricters removed
-20 mm carb
-opened up silencer
-removed clutch bushing
-removed oil resivoir

Procycle!!!

Sponsored Links

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

All times are GMT -4. The time now is 04:49 AM.