K&N powerlid for Banshee

[socket17]

well let us know how it goes.. also the 230 i said i was running is prefect for what i have but i dont know where the clip is at.. might be all the way down lol.

[kxrider]

well thing is u dont have to start messing with ur jetting until like 500ft - 600ft from sea level but in all honesty it be better to run richer than leaner but i would go with 310 main and try that run it see how it runs and check the plugs now i reccomend that u do a high rpm shut down on it to see what tha plugs look like and WOT u kno jus to be on tha safe side

[ASRBanshee]

Originally Posted by socket17

well let us know how it goes.. also the 230 i said i was running is prefect for what i have but i dont know where the clip is at.. might be all the way down lol.

So far the velcro that is supposed to hold down the drycharger has been a pain. Since the powerlid is pre-oiled, they don't take the time to be neat about it so oil is everywhere even on the plastic so the glue for the drycharger isn't good. I'll end up putting super glue to hold it.

Originally Posted by kxrider

well thing is u dont have to start messing with ur jetting until like 500ft - 600ft from sea level but in all honesty it be better to run richer than leaner but i would go with 310 main and try that run it see how it runs and check the plugs now i reccomend that u do a high rpm shut down on it to see what tha plugs look like and WOT u kno jus to be on tha safe side

I was already running like really rich on the mains without the powerlid (300 mains) So I doubt I will have to re-jet. The center of the plug was black anyways so I will see how it goes.

[dustin420]

ehhh i just made my own "powerlid" for my blaster. i took the regular air box lid and cut most of it away but left the edges with the screws then wnt out bought some panty hose and wraped over it. presto done, i can still screw the lid down and it helps with some filtration, i mainly only use it for the sand dunes everywhere else i just leave the lid off compleltly. but still for $3 total invested it works perfectly.

[Wacko Jacko]

this is the most high performance power lid on the market:
its the less dense ,outer layer from a POS toomey filter, flows plenty of air for all of you that are gona give me shit
and yes its filthy, but looks brand new after a few splashes of gas and a run under the hose
note the high quality zip ties and window screen for the front section:

yea its messy,drilled the top out years ago with a 1" hole drill bit as u can tell, before the +10hp powerlid conversion i recently did

precision cuts on the metal brackets to hold the foam in place

window screen, high class



eat your heart out k&n -

[dustin420]

now thats some high quality shit. does it come in a kit? haha

[Wacko Jacko]

sorry its a limited edition only, dont get too excited