vforce3 reeds

[matt66]

where does the 2nd gasket go that comes with the vforce3 reed system on my blaster? i have 1 between the jug and the reeds but wheres the other go? or is it just a spare?

[MX86]

between the boot and reed cage....

[matt66]

doesnt sit right. i left it off.

[climb any hill]

And you'll be fine with out it on that side since there is a seal that goes all the way around.
You might have the wrong gasket too, i noticed my Banshee VF3's a little different, couldn't use stockers..

[02yamahablaster]

I had to trim the gasket a little when I installed them on my YZ250.

[2000BansheeBoy]

I'm thinkin of buyin V3's for my Banshee. Everyone says there a big difference. Is it worth the 225 bucks? Not to thread jack, but how far should I go with the jets?

[climb any hill]

I didn't need to rejet with mine! And one single mod doesn't provide much performance increase.
But get 5 mods going and you'll notice the difference. YOur shee is piped, go for those reeds!!
Look around for deals before buying... I found mine new for $125 and Showtime got his VF2's for $75..

[2000BansheeBoy]

wow, wait, you got yours for $125 where!?!?!?! I found a deal for $215 and free shipping??? and i just found a deal for a flat slide 28mm carb for $250. Which one?

SORRY!! I'm tryin not to seem like I'm thread-jackin but I just keep doin it

[climb any hill]

You'll always find a deal if patient! I found my VF3's on Motosport.com or something like that.
Also found a VF2 for the Blaster, $35 bux! I found two 28mm Carbs for $150 & that's with Airfilters & Outerwears.
Ask around, I'm sure you can go over 28mm for that 2 into 1 setup!

And no worries on thread jacking k!

[2000BansheeBoy]

Cool Beans. I was lookin around for like three hours last night and found a set for like $215 at the least :P On ebay there's one for like $150 but me and my dad are a little skeptical bout ebay...

But I also found a Company claiming it got 1.5 horsepower more out of their reed cage than V-Force 3's. SRP Metals? Ring any bells?