Not runing right

[Alfredo Maldonado]

My 97 banshee has toomey T5 , K&N filter , v-force reeds , cool head, has a mild port , timing key,has good compression starts up on the first kick the problem is that it will idle fine and have good power in idle ,when I put it in gear the motor starts bogging like if it was out of fuel, then it will pop then run good for about minute and do the same thing all over again then it gets hot , I installed a cool head & a new Impeller thinking that was the problem did not fix then I cleaned the radiator, then I noticed my right side carb was leaking so I replaced the float , I rode the bike ran good for a little bit then started to do the same thing again, any suggestions?

[FPMXer]

Unplug the TORS, parking brake switch behind the hood and the little black box bolted to the frame and it should wake up.

[Alfredo Maldonado]

I unplugged the TORS & the parking brake Switch Still the same problem.

[climb any hill]

Hey Fredo!
Made sure you removed the entire system with the tors brain? The little black box?
Is that harness heating up too? How's that flywheel doing? I had that same problem and turned out to be my flywheel.
Made it crazy hot too!

Why do you think it's the jetting? How's those plugs looking?

[Alfredo Maldonado]

The jetting is the last thing that I haven't touched, I was just wondering , And I also removed the little black box from the tors, the plugs last time I checked were full of oil.

[honda250r]

humm pop in 2 new plugs and see if it is the problem

[FPMXer]

If the plugs are black and wet then do like mentioned and see if they come back out like that. If so then it's running fat and at minimum needs a jetting change, repack the cans, and clean the air filter. Have you checked the throttle to see if they are in sync by seeing the silver dot's on the slides in the little windows?

[dajogejr]

Backup...
Did you just do all these mods, did you buy it that way?

What jetting is in it now? Check the jetting, get back to us...

[SHOWTIME]

Originally Posted by dajogejr

Backup...
Did you just do all these mods, did you buy it that way?

What jetting is in it now? Check the jetting, get back to us...

I agree...that will tell us alot.

[Alfredo Maldonado]

sorry I havent replied, I did the mods about 2 years ago, the bike sat for about 4 months , then went out to glamis the bike was working good for about 2 hours then it started acting up booging out and getting hot , the cool head & impeller and float change were done recently.I wil get the jeeting for u guys