| ||||||||
![]() |
| | LinkBack | Thread Tools | Display Modes |
| |||||||||||
| i have a 1999 kx 125,it has black oil dripping from where the exhaust meets the motor and where the header and silencer go together,any ideas |
| Sponsored Links |
| |||||||||||
| i actually just bought it and noticed when i started it up it sprayed oil all over the garage door,could it be that the gas mixture is to rich or the carb is out of adjustment,do you get this kind of thing from a bad crank seal. |
| ||||||||||||
| does it smoke alot when warmed up? when my 250 seal went it smoked alot and the trans oil level dropped.
__________________ My Toyz... ![]() ![]() ![]() ![]() 97' KX125 ~~~~~~~~~ 99' RM250 ~~~~~~~~~ 01' RM80 ~~~~~~~~~ 06' Blaster SE |
| ||||||||||||
| My Banshee did that when running way too rich. Those plugs look good or seeping wet?
__________________ E2S MODERATOR |
| ||||||||||||
| thats how my quadracer is...i run it rich..
__________________ 2003 YAMAHA BLASTER aka "THE ASS BLASTER" fmf, reed spacer, boyesen reeds, 14/38 gears, oil block off, black ac bumper, desert grab bar, skid plate, rear flattrackers/front hole shots, removed TORS, custom seat cover, duncan graphics p.b. block off... ![]() 1991 YAMAHA SUPER JET hydro turf, blowsion chin pad, solas 13/17 impeller, Rule 500 bilge pump, flush kit, primer kit, pro tech ride plate and intake grate, msd ignition.....few other lil things .... |
| ||||||||||||
| Quote:
I'm just a tad rich to play it safe but I don't have any oil oozing from pipes.
__________________ E2S MODERATOR |
| |||||||||||
| the plug has a some oil oil it,it smokes when i first start it up,but after a min,it just smokes like a normal 2 stroke |
| ||||||||||||
| There are two o-rings that seal the pipe and a copper washer that the pipe seats against in the exhaust neck. The reason fuel is spitting out is the engine's bottom end is loaded with fuel. FMF makes a kit with the new copper washer and two o-rings. What pipe is on the bike and what is your jetting at? |
| |||||||||||
| it has a gold series pipe,not sure what the jetting is,i just bought it last week,if i pull the float bowl will i be able to tell what size jet it is |
![]() |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
| |
All times are GMT -4. The time now is 07:37 AM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Cheap Loan | Wikipedia | Xbox Mod Chip | Credit Counseling | Mortgage Calculator
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com






































E2S MODERATOR







.... 

Linear Mode
