Snap!!!

[daBIGstuff]

ok, so i was torqing the bolts that hold the engine case halves together and one snapped??? why i don't know i was using a torque wrench and didn't even feel it slip.

anyway the bolt broke pretty far down and i don't want to split the case again. do they make a tool that is similar to an easyout but will reach in a hole about an inch.

also do you have to get new bolts when putting the case back together? or can you reuse the bolts.

thanx in advance!!!

[B-RAD]

If you see a tool truck runnin around stop him,snappy should have somthing.

[lt250racer]

Id just split them & Take the broken screw out. You may run into problem later if you dont have the proper torque on that part of the case.