rc car help

[4x4kingx889]

i need help adjusting the carb were should the air screw be at?

[rm250dude]

is the carb a 3 needle carb or 2

[rm250dude]

if its a 3 needle carb the idle/air screw should be on the side of the carb and the fuel screw is right above the fuel line and if its a 3 needle carb there is a mixture screw on the top of the slide

[4x4kingx889]

ill look in a hour

[DStad]

what kind of car and it should be the one sticking up straight. it like a garden hose spigattet. if you loosen it it will allow more fuel which means richer. if you tighten it it will allow less fuel and more air which equals leaner.

[4x4kingx889]

well its a durmax and there is 2 screws one were fuel comes in and a other one

[4x4kingx889]

here are some pics

[4x4kingx889]

i took them with cell phone....also i broke pull starter so i have to use a drill now which i think is better any way

[russp]

well it looks like the high speed needle is in too far, usually the high speed 9 where the fuel enters) is turned out about 3 turns( dont screw in too tightly to begin adjustment)
low speed is adjusted so it is flush to start.
Then start adjusting the highspeed needle in 1/8 of a turn as your running the car, until the top end is set
Hope this helps

[4x4kingx889]

so whats a good start i dont like starting it and haveing it rev all high