99 Scrambler 4 X 4

[gh500]

it works the 2 electromagnets on the front struts they put a drag on the wear plates on the roller clutch causing the roller clutches in engage hub

[gh500]

one more thing if you tear the front en down make sure you put the wear washers in with the tabs in the roller clutch they will fit the other way but will tear up the 75$ electromagnets i've had several come in that have trashed 150$ worth of coils b/c it was in backwards
one last thing if you need roller clutches or an axle they made 2 different ones btb & ntn 20 & 22 spline

[BIGBLOCKXJ]

Just got back from tearing the left front apart. We found the cage broken, boot torn, and one ball out of the setup. I went over and ordered the parts, (btb) will take about a week to come in.

Last question (I hope)....Is there a clip to remove the cv joint, or is something else narfer up because it will not slide off?


Again, thanks for all you help!!!

Mike

[gh500]

yes their is a clip they can be a real pain to get apart sometimes they just pull apart but if it's already missing a ball it's probably loose enough to roll the others out & then roll the cassette (ring that holds the balls) up & twist the axle & take it apart that way then remove the clip
just curious where did you get your parts ?
here is a link to cheep polaris parts i think the joint kits are 60-70$ great buy to deal with
www.psep.biz

[BIGBLOCKXJ]

From the local dealer $140. I guess I blew it!!! Great resource!!

Thanks,

Mike