| ||||||||
| | LinkBack | Thread Tools | Display Modes |
| ||||||||||||
| Ok, we now have Noss Machine cool heads, domes, and o-rings available. You can check them out at the site www.rjatv.com ![]() ![]() ![]()
__________________ 2006 Banshee SE 421 Cheetah Cub with a clean up port on race gas CPI In Frame Big Bores V-force III Boss Intake 34mm PJ'S +4 Dura Blue Axle Duneable Tranny 1-5 neutral down Lock-up with a Pro-Lock Clutch Everything else is pretty much stock 1989 LT250R FLOTEK Ported FLOTEK Head Mod FLOTEK Lightened Flywheel Nology Coil And Hotwire Ported Reed Cage With Boyesen Carbon fibers Keihin PWK 38mm Airstriker/Pod Filter K&N FTZ Pipe/Silencer 2 RJATV.COM Stckers (4hp gain) She runs like a raped ape, I am able to beat piped shees with her, not bad for a little old 250. |
| Sponsored Links |
| |
| ||||||||||||
| BUMP good parts and Orings are always a must! did you get my pm ? once my rings are figured out what size i need I'll be ordering some o-rings too
__________________ |
| ||||||||||||
| oh heck ok lol.. I had sent you an IM "let me make sure it is the right size i know they are 6550" and i asked how much they are so i could put it in the bank. but yeah we shall figure it out can you check piston sizes off the numbers?
__________________ Last edited by 8-Ball; 02-27-2008 at 01:17 AM. |
| ||||||||||||
| Yah get me the numbers off of the top of them and i can tell you what size they are.
__________________ 2006 Banshee SE 421 Cheetah Cub with a clean up port on race gas CPI In Frame Big Bores V-force III Boss Intake 34mm PJ'S +4 Dura Blue Axle Duneable Tranny 1-5 neutral down Lock-up with a Pro-Lock Clutch Everything else is pretty much stock 1989 LT250R FLOTEK Ported FLOTEK Head Mod FLOTEK Lightened Flywheel Nology Coil And Hotwire Ported Reed Cage With Boyesen Carbon fibers Keihin PWK 38mm Airstriker/Pod Filter K&N FTZ Pipe/Silencer 2 RJATV.COM Stckers (4hp gain) She runs like a raped ape, I am able to beat piped shees with her, not bad for a little old 250. |
| ||||||||||||
| I got a question, will those domes that you have for sale work with a prodesign coolhead??? and what is the smallest cc dome you can use and still be safe with premium pump gas?
__________________ 86' honda 250R woods bike fresh motor as of sept. 9th 08' esr trx 5 pipe and silencer 38mm air stryker carb stock cyl. with 68mm wiseco piston (86') cr thin head gasket 180psi compression (stock head) 88' hot rods stock crank with spacer plate vforce 3 reed valve 01 cr250 ignition system +4 axle 13/38 gearing durablue lowering strut maier front and rear fenders |
| ||||||||||||
| #1 yes #2 usually its 20cc unless your at sea level unported - then try 21
__________________ CLICK BELOW FOR MY NEW SITE http://flotekperformance.com/home http://www.rjatv.com/ cheapest ^^performance parts online |
| ||||||||||||
| Yah what Denny said.
__________________ 2006 Banshee SE 421 Cheetah Cub with a clean up port on race gas CPI In Frame Big Bores V-force III Boss Intake 34mm PJ'S +4 Dura Blue Axle Duneable Tranny 1-5 neutral down Lock-up with a Pro-Lock Clutch Everything else is pretty much stock 1989 LT250R FLOTEK Ported FLOTEK Head Mod FLOTEK Lightened Flywheel Nology Coil And Hotwire Ported Reed Cage With Boyesen Carbon fibers Keihin PWK 38mm Airstriker/Pod Filter K&N FTZ Pipe/Silencer 2 RJATV.COM Stckers (4hp gain) She runs like a raped ape, I am able to beat piped shees with her, not bad for a little old 250. |
| Thread Tools | |
| Display Modes | |
| |
All times are GMT -4. The time now is 08:51 PM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Loans | Debt Help | Myspace Images | Coin Community | Xbox Mod Chip
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com













































Linear Mode
