Wanted 85 lt250r cylinder and 95 kx250 cylinder

[davidonmars]

if anyone has either cylinders for me with some bores left on them let me know. Thanks

[b.lee]

I have two 85/86 LT250R Cylinders.
The cylinder with all 3 studs where the exhaust bolts up is a little rough on the gasket surface. It would most likely need some TLC to seal up right.







Make offer.

[b.lee]

[b.lee]

[b.lee]

[b.lee]

On the left hand side of this picture, on the edge of the cylinder, were the base gasket would sit is a little rough.

If you get the cylinder bored at a decent place they will hot tank the cylinder which will clean the jug up nicely.

[chopper666]

look at my parts 4 sale buy a engine that runs for dirt cheap

[sblt500r]

i have a couple kx250 cylinders. but they need to be resleaved. let me know if your interested. one is a 93 and the other is from a 98. both will fit the 95. the 93 has a sleeve already in it. maybe you could get an overbore piston?

[BadAzz88GT]

I have a ported PSI cylinder for an 85, it will need to be resleeved, also have the matching PSI pipe for it. Here are some pictures:











Make me an offer, I was gonna just ebay it.

[BadAzz88GT]