| ||||||||
![]() |
| | LinkBack | Thread Tools | Display Modes |
| Sponsored Links |
| ||||||||||||
| Whats the belt supposed to go onto?
__________________ 2001 Yamaha YZ 125 Gold Frame RG3 Suspension Answer Pro Tapers Boyesen Water Pump Twin Air Powerflow Air Filter VForce 3 Reeds FMF Gold SST Pipe/FMF Titanium 2 Silencer Excel Colorworks Rims (Gold) Pro Circut Magnesium Clutch/Ignition Covers Hardstyle USA Sprockets/DID VM X-Ring Chain Wiseco Hot Rods Crank w/ Athena Cylinder Kit Braking Rear Caliper w/ Braking Wave Rotors Rifled Carb RG3 Triple Clamps Hinson Pressure Plate, Basket, Springs, and Hub Hydraulic Clutch Lever |
| ||||||||||||
| its for my old attex 6 wheeler. it uses a snowmonile type drive belt. a few years back i stole the belt off an old artic cat puma, and cut the sides down to fit, and after it ran awhile it cleaned up nice. but i just recently found what belt it used originally, and wanted to get something close. |
![]() |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
| |
All times are GMT -4. The time now is 02:02 PM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Car Loan | Mortgages | Debt Consolidation | Neopets Cheats, Games and Neopoints | Neopets Cheats, Games and Neopoints
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com





































Linear Mode
