Raptor front master cylinder on an lt500r?

burgiebird · #1 (**permalink**) 03-10-2008

Any one know if this will work on my zilla? It is a new technology and I think I could get better brake pressure out of the fronts if I use one off of a rappy. What do ya think? http://cgi.ebay.com/ebaymotors/yamah...QQcmdZViewItem

crazetoride · #2 (**permalink**) 03-11-2008

maybe a little better, best mod is better front calipers

qzillanut · #3 (**permalink**) 03-12-2008

I just put a front master cylinder off a LT450r on my zilla. Can't say it has any better pressure, but it was a lot cheaper than buying a new master cylinder, and my old one wasn't fit to rebuild. Only thing I had to change was the hollow bolt. They were the same size, but had different thread pitch.

jsmstorm · #4 (**permalink**) 03-12-2008

I would think that you would be able to make most any front master cylinder from a quad work hell there was someone on here who had one from a cr250 on his lt250

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode