Stuff that swaps out

[superevil]

I have a thumb throttle from a 1984 honda 200sx. I like it much better than the lt250r throttle

[sblt500r]

use a lt500r clutch cable on the lt250r. they are longer to reach on those taller handlebars. they have the same ends so they will fit with out any mods.

[gh500]

ok who as actualy swaped z400 hubs & rotors to a lt ? do the z400 calipers fit the lt knuckles ?

[terboed]

Originally Posted by gh500

ok who as actualy swaped z400 hubs & rotors to a lt ? do the z400 calipers fit the lt knuckles ?

if this actualy works, i would be interested in doing it to my 91. the front brakes are the ONLY thing i dont like about it. they are a horrible design and dont work for shit. drum brakes would of allmost been better.

[gh500]

well 2 things i have found cause bad front brakes 1) worn front brake lever it's amazing how much a little slop will affect the front brakes 2) bent spindle or caliper brkt squeeze the front brakes see if the caliper rocks is a dead give away to that some other things that can cause bad front brakes is loose wheel bearings 20 yr old rubber lines swelling check to see of you have a rocking caliper & try a new lever you will be surprised

[wade280]

well the banshee rear hubs on a 85-86 works great, as far as fit. havent rode them yet, but they fit tighter than the stock hubs so there should be a problem.

[RenLT250R]

I think the 400ex a arms work on the 87-92. I got a set and they well bolt right up i just have to make sure the ball joint fits in the spindle. I well let you guys know when i get them on. They work out to be like a +2 maybe 2 1/2!!!!

[gh500]

stock or aftermarket 400 ex arms ?

[CR480R]

I read that 250r a-arms bolt on too. Lets see a picture. Thanks.

[370banshee]

just use 400ex spindles, brakes, and hubs... then you'll use a waymore common brake pad and the 400ex brake work so much better and the pads are easier to change.... and you can ru a way mroe common honda bolt pattern wheel up front..