Suzuki Lt250r cylinder

[barnesrm]

I read where someone used a Polaris watercraft piston to get another bore out of a Lt 250r. Which watercraft which piston what part #. Did this really work? Help

[NOS500]

i dont think its such a great idea.... just use a wiseco

[nickbroker]

<agrees with nos lol

[barnesrm]

Where can I get my jug resleeved.

[barnesrm]

Where can I get my jug for a Suzuki Lt 250r resleeved?

[tecateboy]

from what iv heard its usally cheaper to go and buy a good used cylinder for it instead of getting yours resleeved.

[Carter124]

well im not shure about the polaris but with a great borist you can use a yz 250 piston

[Joe Rock]

As for resleeving...I know a few guys locally here that highly recommend LA Sleeve. They ride two strokes as well. They send the jug out to have resleeved...good turn around time and excellent work. www.lasleeve.com

Not affiliated with them at all...I started asking around since I am currently rebuilding my LT for the last time on the factory sleeve (2 mm over). I will need a resleeve next time, due to my porting in current cylinder, I would rather have it resleeved than go with new jug. HTH

Joe

[mgty3whlr]

I'm using the polaris piston with great success. the part # is wiseco 722M06970
The pin bearing # is B1014. I used 3 base gaskets because the piston is 1 mm taller and just mod the intake skirt. Runs great and is reliable.

[fiveOnick]

LA sleeve does do a great job, just had the old 310 resleeved there. Go figure they make the cylinder and they do a nice job of resleeving it.