burgard a-arms for lt's

[braindonor138]

has anybody ever used these or heard anything about them??burgard racing

[800screws]

i have a set. sometimes there is a wait if u order from them, but the a-arms are good. i run them on mx tracks.

[braindonor138]

Originally Posted by 800screws

i have a set. sometimes there is a wait if u order from them, but the a-arms are good. i run them on mx tracks.

what size do you run on your quad??

[800screws]

+3's, but i have hsd hubs that run 4 1 offset rims. if u use 3 2 offset u need +2's.

[Banshee]

Is that because of regulations for racing being what 52"? Is that why you need the 4 1 offest? Do you have a link to the HSD hubs?

I am looking at a set for my LT and we are going to race it and I was not sure what size a-arms I need.

thanks

Jason

[800screws]

yeah, 50" is the legal limit. that's why u have to run 4 1 offset rims, at least with +3 arms. i went with this route, trying to make a smoother front up because of the wide frame rails. plus the rims protect your spindle, caliper, etc. i don't have the link, just trying searching "high speed dirt racing"

[cr80racer]

i found a kit somwhere with the whole front frame that makes it more like a 250r with a skinner frame, it also came with 4.5 extended a arms and gave the wimpy front end of the quadracer 12.5 inches of suspention or something like that, they also had a rear swingarm that was curved for more travel

[braindonor138]

Originally Posted by cr80racer

i found a kit somwhere with the whole front frame that makes it more like a 250r with a skinner frame, it also came with 4.5 extended a arms and gave the wimpy front end of the quadracer 12.5 inches of suspention or something like that, they also had a rear swingarm that was curved for more travel

can you get some more info about that like a site or something???

[cr80racer]

ya ill see if i cant find it, it looked expensive because it came with everything like elka shocks and tie rods.

[cr80racer]

hey i got it, http://anzwers.org/trade/hsdracing/main/frames.html this is where i found it