clutch wont engage ??????????

[rm250dude]

i had my rm 250 out and i was gonna go take a little run in the snow with it and i pulled the clutch lever in and shifted into 1st and it just quit so i turned the clutch cable adjuster out more and more and it still wont engage wtf?!?!?!?!?

[rm250dude]

anybody know?

[rm250dude]

shit i thought this would be an easy 1 for ya guys

[daBIGstuff]

your clutches are prob beat. thats what happend to one of my friends

fat kid + 125= beat clutches they also wear out over time. measure them to find out.

[rm250dude]

aight ill look at em 2morrow i guess

[rm250dude]

i had the same prob with my old rm but it just turned out that the dumbass who put the clutch in forgot a steel plate

[lt250racer]

You need to give us a little more information:
When you pull the clutch in, is there tension?
When you engaged it into first, did it slip a little & then stall, or just stall hard?

[rm250dude]

yes there is tension when i pull the clutch in and when i shift into first while im holding the clutch in it just stalls hard

[rm250dude]

wat should be the measurement on the plates also???i gotta find a caliper to measure them

[lt250racer]

Im going back to the house where my lt is, Ill look in the manual, I dont know if there the same, but they should be similar.