Banshee Swingarm brands

[CHAD]

whats out there for banshee swingarms? I tweaked mine a tad today, i'll got a used stocker for now, but i wanna look into an aftermarket one,

[ltracer250r]

i know that janssen racing makes one for sure www.janssenmotorsports.com

[flotek]

Chad ,get a stocker modified to run a -2 banshee swinger length (ebay ) ,this is the hot setup for mx and trails on a banshee ,really tracks the ground and is more flickable and responsive in turns too
ive read a ton on this mod and it is really the way to go for a mx setup from what ive researched

[CHAD]

i just hope i don't get the swingarm where they learned how to weld on. lol. i'll look for one of those, sounds good.

[CHAD]

hey, i've got a spare stocker... anyone know a place that would mod it into a -2 for me?

[sblt500r]

take a sawzall cut it in half the measure 2 inches and cut it again and weld it up and there ya go. hahaha

[CHAD]

If i knew how to weld i'd give it a shot, lol, but i found myself a -2 swingarm.

[dEcon]

quicksand motorsports can shorten stock swingarms for 140

[91LT250R]

Tons of companies make swingarms for the Banshee. Most of the big names like LSR, Laeger, and Roll Design make them, but smaller or less known companies such as Eyeball Engineering also make them. I googled "Banshee swingarm" and even found companies that I have never even heard of offering Banshee swingarms. Two of these companies that I have never heard of are Metal Tech and MotoQuad. The only experience I have is with stock Banshee swingarms so I can't give you a review of any.

[ltracer250r]

cut a 2 inch piece out of it and JB weld it back together and Voila! your done.