Idle Kit For Banshee

[uniteam]

Hello, I'm new on this forum... I'm trying to find here information about it, but the SEARCH option doesn't works for me.

I removed the original equipment carburator switches, I have been replaced them by standard carburators caps. And I want to install the Idle kit, but I have a lot of doubts on what is the correct hole that I have to drill..

Can you help me???


Does it the big one of the center?? or the little one that is near to the reeds side :-(


some picture??

thanks

My banshee is 1992 and the Carbs are the stock mikunis

[MWC]

drill the holes on the outsides of each carb ( meaning the left side of the left carb and the right side of the right carb) drill the hole that goes directly into the throttle bore, drill all the way into the throttle bore....................then, dont forget to file the end of the idle screw boss flat so that the idle screw washer can seat flat, for some reason this boss comes finished with an angle

[Yfz350W]

Here's a pic of my dirty carbs. (Too lasy to wash her when i was done today)
The idle screws are just under the cap locks.

[flotek]

i have a new sealed banshee Toomey idle kit for cheap if anyone needs one -sorry just thought id throw that info out

[terboed]

Originally Posted by eviltwin

i have a new sealed banshee Toomey idle kit for cheap if anyone needs one -sorry just thought id throw that info out

ill trade ya for some slightly used TORS boxes..... lol