shee low end torque

[06menace]

Hi guys. need some advice.
Ive got a stock banshee, brand new and just run in the motor.

Im on a very limited budget as I am still paying for her.
any advice on low cost mods to improve the dead spot low down?
she performs brilliantly in her pwerband but under that she is a dog

[flotek]

milled stock head and lightened flywheel = no more low rpm bog and hesatation

[yamaharider02]

ya and it aint that expensive either, after that id say save up sum money and buy a nice low/midrange pipe

[538 banshee]

he's right rechamber the head to 19cc lighten the flywheel and advance the timming, also you can remove the end caps on the silencers take a punch and knock a hole in the cone in the silencer to allow better flow remove the air box lid if you are willing to get a pre filter and jet up a couple sizes on the main depending on elevation they run pretty good and its real cheap

[Aussie Bloke]

chuck some pod filters on it and bump the main jets up to 240's my buddies did that i was very suprised with the difference

[ghstrydar]

So how much do you lighten the flywheel and where do you get this done?
I am hoping to come up with the money for a Noss head what cc dome should I get? I hope to install the SST FMF headers this summer. Since I am a teacher I am trying to do a mod a month on small stuff and use part of my summer school pay check for the exhaust system. I have a stock 03 the only mod is a vitos impellar which I should have bought through MODQUAD, since it came in modquad packaging but with the VITO's price
So does the impellar count as my first MOD?

[bs traction]

pm eviltwin on the flywheel and head mods there will worth it and add nice lowend

[ghstrydar]

Thanks i will pm him in the morning

[lawbraker]

on the pipes cpi infram are the best you can get right now thay are a little more but well worth it in hp

[Aussie Bloke]

to raise the torque milling the head makes a BULLSHIT difference! i couldn't belive it was a banshee motor after my mate milled his head for 98 octane