banshee carbs

[bazza789]

hi im new to the site. was wondering wat is the correct size of carbs for a shee with a pyramid intake dri cool head not sure on dome size some porting trued crank and dmcs i measured the keihins on the bike and they are 36mm all the screws are on the left of the carbs the drain bung was removed and replaced with sum sort of fibreglass on lhs to stop the clutch rubing but it still does
the bike appears to be flooding the LHS cylinder i bought the bike before christmass off ebay in the uk

http://cgi.ebay.co.uk/ws/eBayISAPI.d...MEWN:IT&ih=018

thanks

[Smkmup]

Well first and foremost, welcome to the site!!

2nd, Those carbs might be good for your setup...I'd try to repair them and buy some replacements parts for the carbs and do a rebuild. Also check the jetting, maybe for some reason the jets are bigger in the left carb??

[370banshee]

damn u got that bad boy cheap... that chassis is sweet..

passion racing port my martin? hmmmmm


anyway those carb should be OK.. like steve said make sure they are in proper condition then go from there

[bazza789]

thanks i was wondering though y the screws are all on the left? wat should i do to stop the clutch rubbig or shud i ignore it

[bazza789]

also was wondering how do i "watch" or enroll r watevr 2 a thread
thanks

[370banshee]

it automatically subsribes you to a thread on this site. if you have ur options set to email updates...

oh and for the clutch arms problem... buy some cheap reed spacers it pickes the carbs up just enough to clear that arm

[Smkmup]

I believe I have a set of reed spacers for sale if your interested....

[bazza789]

no thanks it would cost too much for shipping i think as i am in ireland i can get a set off ebay deliverd 4 £27 prob about $50 thanks anyway and thanks for the help

[Kane]

The screws are all located on the one side as those carbs are generally designed with a single-cylinder engine in mind. Can be a pain in the ass when trying to use them on a twin.