banshee trouble

[rkpolaris]

Hey im new to the forum and I have some questions about my 2005 banshee.
I just did a top end re build and had to have it bored out to 65.25mm. I used wiesco pistons, but it wont idle, it just loads up with fuel and real doggy in low end...any advice?

Mods:
-Pro design cool head w/18cc domes
-pro circuit pipes
-v force reeds w/reed spacers
-degree key +4


elevation- about 1000ft above sea level

[dunecoon01]

check your carb slides . do you still have the TORS on the bike if you do unplug the box under the left side of the gas tank . might fix it if the carb slides are in right

[rkpolaris]

sorry im not sure what box you are talking about

[dunecoon01]

look up under the front of the tank should be the only box there with wires attached unplug it

[rkpolaris]

ok i did that and no luck

[dunecoon01]

check between your carbs for the tube that runs between your carbs , did you double check your slides

[rkpolaris]

that tube is connected, and what should i be looking for at the slides?

[joee20002]

check compression..............

[joee20002]

and clean your carbs they could be dirty from the re build.

[rkpolaris]

i cleaned the carbs...what should the compression be at