blaster problem

rtscaptain · #1 (**permalink**) 02-22-2007

ok, well i picked up a 1990 blaster for 600 bucks, it was complete with a set of paddles too. But it was pretty much in peices. well after putting it together it started on the second kick and idles great, but when ever you give it any sort of gass it dies immediately. whats up????

BlueDiablo · #2 (**permalink**) 02-22-2007

whats the plug look like? Could be very bad jetting. TORS possible too.

joe22883 · #3 (**permalink**) 02-22-2007

wasnt you hating on blasters a few weeks ago?

rtscaptain · #4 (**permalink**) 02-22-2007

nope, i just asked why some of you people put so much money into them. Why would i hate on something when i have two of them

joe22883 · #5 (**permalink**) 02-22-2007

probably tors i had that same problem on my banshee and someone told me to check that it it turned out to be the problem..

rtscaptain · #6 (**permalink**) 02-22-2007

ahh, so would disconnecting it fix the problem?

joe22883 · #7 (**permalink**) 02-22-2007

all i did was unplug it and it allowed it to rev then i ordered the tors removal

revin-it02 · #8 (**permalink**) 02-22-2007

you can just unplug it and it will be fine for awhile... till you can like get the kit...

skipzero · #9 (**permalink**) 02-22-2007

Just follow the yellow and brown(I THINK)wires OUT OF THE THUMB TROTTLE to where it has a plug in the line. Unplug the plug and cut the end off the end that is goin to the motor and contect the brown and yellow wires together. I'm not sure if that is the corect colors but just follow the two wires that come out of the thumb trottle. Your tors will be delt with after that.

ONLY2STROKES · #10 (**permalink**) 02-22-2007

thats the correct colors.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode