Im goin' in!

[6.5silverado]

i just ordered a clutch kit and i am going to put it in when i get it. ive never done it on a blaster before. any advise, or suggestions?

[SandGeek]

Easy money. Pay attention, take your time and you'll be fine.

Never done it on a Blaster or just never done it?

[Paulie B]

Don't sweat it. Take the clutch cover off and everythings right there and easy to get to. Just pay attention to the the order of the plates and put it all back just like you took it off. Take some pix if you feel more comfortable with that...PB

[xxxbansheexxx]

pb good advice
take pics

[honda250r]

make to soak the clutch plates like the instuctions says and advise from me is makesure you gedt the pressure plate on the hub correct or youll be pulling it all apart again to fix it and then the gasket will be bad

[dookieshoot-rider]

Its really simple stuff.....nothing a six pack can't get you through!

[bkg479]

I have done it atleast 8 times, alls you have to do is make sure you soak the plates in the trans oil, then take the plate off, and put the new ones in, friction metal friction metal, there is one that is smaller than the rest, that a little spring goes in under, you will see when you take it apart, also dont forget that after you take the plate off and the push rod, there is a little ball behind it, dont loose that, and lastly the pressure plate has a little dot on it, make sure it lines up with the little dot on the basket, adn you should be all set. If you get stuck ask or just get the manual, it is very clear in the manual on how to do it, if you dont have one there is one on the fourms somewhere thats where i got mine from.
Good Luck