I'm Finally building my blaster

[dualstroke]

Looks good man.Good luck.

[dualstroke]

Give RJ ATV a shout.I'm sure he can help you out with the chain.

[Mert]

Originally Posted by FTZPoweredBlaster

Looks good. Although that carb might be a bit small for a 240 kit & a 3mm stroker, but it should have great throttle response down low & fall a bit short on topend power.

yeah, i was talking to Curt at project blaster and he said since i had a vito's 240 kit that the 30 mm would do fine, at first i was going to get a 35mm airstriker, but funding ran short and he told me that, so i got the 30. But i like low end power anyways.

[FTZPoweredBlaster]

www.rockymountainatvmc.com usually has the best price. If you are trail riding get an o-ring or x-ring chain. If you mean you want more top-end speed, put a 14 tooth front sprocket on and/or 22" tires on the rear. I am running 14/39 gearing on my blaster with 20" tires and I like it a lot. As far as jetting goes, might wanna ask flotek that one.

[Mert]

thanks for the advice, i think im gonna go with RJ ATV, his chain is about 1/2 as much, and i plan on extending the swinger about 3 inches so i will have to get a longer chain then. And I'm running some 20x11 inch tires right now, also should i get the vitos timing advance key?

[MADILL]

adding teeth on the front and takin teeth off the back gives you tallers gearing ...see what you got on it know and go from there

[Mert]

so took my blaster apart and power washed the frame, then painted it. Put the engine in there and tomorrow i will clean and paint the swinger then put it all together. Check out the gussets i put in the frame.

[vspec]

That pic of the reeds, is that what bad reeds look like?

[Mert]

yes, theres a burn mark on part of it actually.

[honda250r]

reeds should close all of the way touching the reed cage