| | |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
04-11-2008
| ||||||||||||
| ||||||||||||
 Tors I Am Puttin Blaster Engine In My Lt 250. I Will Be Using My 34mm Carb. What Do I Need To Do About The Tors? WELL I GUESS THE tors is gone, so what do i do about the wiring?      |
| Sponsored Links |
|
04-11-2008
| ||||||||||||
| ||||||||||||
| well since you don't have it on top of the carb, you will just need to adjust the wiring harnes. look at the wiring diagram and cut out everything that says torrs... i am pretty sure there is a wire diagram on here showing the tors cut out, i will search around for it...
__________________ She offered her honor, he honored her offer, for the rest of the night he was on her and off her.... 96 banshee rebuilt from ground up.... pro circuit pipes, milled head, mossbarger reeds and cages.... 84 200x it's a tank, rhino lined fenders, make it bullet proof 84 xr80 it was to cheap to pass up, and it's good to the take the crapper on cold mornings at the dunes, when you don't wanna wait for the shee to warm up |
|
04-11-2008
| ||||||||||||
| ||||||||||||
| Duneman Is That U In The Avitar? If So Maybe You Could Come Over And Show Me How! I Found The Electrical For Blaster And Printed It, But It Doesnt Tell How To Get Rid Of The Tors. Im Surre This Has Been Discussed A Million Times. Oh And I Found A Complete Blaster Harness In The Garage. |
|
04-11-2008
| ||||||||||||
| ||||||||||||
| PM Sent.....
__________________  E2S MODERATOR |
|
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
All times are GMT -4. The time now is 06:02 PM.
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0 Shares | Per Insurance | Loan | Loans | Gas Suppliers
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
Copyright 2005 everything2stroke.com
