shifting troubles

[jeffy]

well i finally got it running properly and i was out for about 2 hours it was workin fine then i went threw some water and it started to fall out of gear and if i got it into gear it would fall out if i tryed to shift or just on its own sometimes if i roll it backwords and shift it, it will go into a gear WHAT IS GOING ON HERE

[FPMXer]

It only started the trouble after the fording? You might have a bad shift shaft seal or right side engine cover gasket that allowed some H2O to mix in with the oil. Drain the oil and replace and also clean the bike and inspect the shift shaft seal and right side engine cover gasket. Or worse you cracked the case and water flooded in.

[ttbanshee_rida]

man u have the worst of luck i feel ur pain

[jeffy]

how would i change the shift seal or even check it?