Where to start? Jetting

[nickypbonez]

By early next week I should be getting my head back from flotek and I need your help on where to start as far as jetting goes. My mods are listed below

Stock engine bored .90 over
Head is milled for pump gas
Delta V-Force reeds
Stock Carb w/the airfilter clamped on
Full FMF exhaust
oil block off

believe that's it for things that make a difference

[NELSON]

WE GOT almost the same set up on suggys blasty. we run a 320 main i beleive( largest one in vitos kit) clip is on #4 position from top. the only thing different is we gotta stock head. either way even with stock carb it is a huge improvement. ull be happy. for awhile anyway! i use to spank her on the kx 80 when she only had pipe. now the kx cant even touch the blasty

[nickypbonez]

I figured it would have to be a large jet is vito's the only place I can get this?

[NELSON]

i am not sure but they sell the needle and a larger pilot jet and a few main jets. very easy to understand directions. get with rjatv in the vendor section on here and he can get u a better deal then vitos will give you. and i made a small mistake. i thought urs was ported. sorry.you could probally just faten up that main jet and be fine. did u already have the other mods other then the milled head?

[nickypbonez]

nope nothing else other than whats listed. I put alot of money into a shee and it got stolen. So i had a blaster given to me that I just use to go up and down the road as fast as I can. The only other mod might be a small nitrous kit

[NELSON]

you should look into porting. that sucks about the shee. those are grounds for a shootn

[nickypbonez]

I considered it but it was going to put me over my budget and I would have to sacrafice other mods that I wanted to do. Plus my overall plan is really to keep an eye out for another shee and just sell the blaster

[nickypbonez]

another question I was just over at vito's performance ( I'm gonna call rjatv back, he didn't pickup yet) anyway i saw a couple of things for the blaster first the tors eliminator kit. Does this do anything as far as performance? Second they offer and advance degree key you just need a flywheel puller. Does anyway know about performance on this?

[socket17]

ehhh the tors remover doesnt increase preformance.. just a little less weight.. and the degree keys have a issuse with snapping and wreaking your bike.

[NELSON]

TORS wont do anything as far as performance goes. dont think the degree key will help considering your mods. and yes you will need a flywheel puller to install the key